We have Itero scanner and Inlab Software in our practice. Milling unit is MCX5. My problem is when we get preps done for crowns / veneers in both the arches, it is not possible to design them in the inlab SW as the software asks for a occlusion stl file to upload and there is no occlusion stl file in an itero scan. Please advise how do I go about making crowns in both arches?
As of now, I design crowns in one arch, then go back to administration - create a new layer and then start again with the other arch locking the first one.
Hope this makes sense.
Look forward to getting some solutions here. thanks
Regards,
Rajiv
As of now, I design crowns in one arch, then go back to administration - create a new layer and then start again with the other arch locking the first one.
Hope this makes sense.
Look forward to getting some solutions here. thanks
Regards,
Rajiv
Comments (6)